Programming Instructions Adding replacement Triad control fobs to your vehicle.

·       Turn on ignition and LED will start flashing rapidly. (the LED is the red flashing mounted below the dash)

·        Present a functioning transponder (key chain or card) to ignition antenna. The antenna is located around the ignition key cylinder. The LED will give a long blink and then go out. Note; The Triad III system’s antenna is located in the LED housing.

·        Turn the ignition to the off position. LED will blink rapidly.

·        Wait 3 seconds and then present the programmer Fob or card to ignition antenna. The system will beep twice, the LED will stop for a Moment and then start blinking and make a ticking sound.

·        Present each one of the Fobs, one at a time, to the ignition antenna and the LED will give a long blink and a beep to confirm the Fob has been accepted. The Triad system will learn up to 6 fobs. Any fobs not programmed will not operate the system.

·        To confirm programming is correct, try to start the vehicle without a Fob and then with one. Wait until the LED begins to flash slow Red before testing each fob. The slow Red flash confirms the system has rearmed.

·        Repeat this process if all of your Fobs fail to start the vehicle.